Uncategorized

Ferris wheel

Written by Victor

This project was completed as part of a technical brief. It is made from 3mm-thick balsa wood and glued with cyanoacrylate adhesive. It is a model of a rotating Ferris wheel.

For the beginning, the round base is cut to which the nerves will be rolled out in two copies.
After that, already to him fastened nerves they are located on against each other at cianocrylate glue.
In the future, the edges are fastened with a section of 3mm to close the contour of the wheel.
Now it is made of the foot on which the wheel is attached is also made of 3mm balsa.
We need to make legs on which the wheel is attached they are divided by empty spaces to accommodate wires.

6 thoughts on “Ferris wheel”

Leave a Reply

Your email address will not be published. Required fields are marked *

Skip to toolbar